Sets include a handle and an assortment of tips for holding and positioning wire, springs, and other small parts.

Change tips to use a different size or style pick for holding and positioning wire, springs, and other small parts.

The assorted tools in these sets are used to hold, separate, and position wire, springs, and other small parts.

A different tip at each end allows you to install, extract, and position parts with one tool.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components.

Made of beryllium copper that is FM approved, these picks satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Shaped for removing the seals around bearings, insert the tip of these tools behind the seal and pull. The curved head provides leverage to remove stuck and stubborn material.

Replace tips when they become worn or to use a different style. The corkscrew tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

A different tip at each end installs and positions tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

The assorted needle-sharp picks in these sets are similar to dental instruments and suitable for work around delicate circuits and components.

Made of beryllium copper that is FM approved, these pullers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use to extract material from tight spots.

The assorted picks in these sets are used to install and position tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Pull material out of tight spots. Similar to removing a cork from a bottle, the tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.