McMaster-Carr logo
    Filter by
    Container Type
    Manufacturer Model Number
    Color
    Locking Strength
    For Maximum Thread Diameter
    Manufacturer
    Breakaway Torque
    Maximum Temperature
    Removal Method
    Cure Type
    Consistency
    Clarity
    Reaches Full Strength
    Mixing Required
    Minimum Temperature
    Begins to Harden
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    2 Products

    Threadlockers

    Image of Product. Front orientation. Threadlockers. Threadlockers, Bottle.

    Bottle

    The most commonly used threadlockers, these liquids prevent loosening due to vibration, bending, or improper torque. You only need a few drops to evenly coat threads. As you twist parts together, exposure to air is blocked and the threadlocker begins to harden.
    Primer (sold separately) cleans the surface and decreases the time to reach full strength. It is recommended when working with aluminum, stainless steel, and titanium; black-oxide finishes; and cadmium and zinc coatings.
    Low Locking Strength—Often used in setups that require frequent disassembly, these threadlockers are easily released with the turn of a screwdriver or L-key. They give fasteners additional hold to keep them secure against light shock and vibration.
    Thin Liquid—Seep into tight spaces better than thick liquids, so they're best for fine threads.
    Container
    Manufacturer
    Model Number
    Size
    Type
    Begins to
    Harden
    Color
    Breakaway
    Torque
    Temperature
    Range
    Consistency
    Viscosity
    Reaches Full
    Strength
    Each
    Low Locking Strength
     
    Loctite®
    2220.34 fl. oz.Bottle20 min.Purple50 in·lbf-65° F to 300° FThin Liquid1,200 cP24 hr.0000000000000
    2221.69 fl. oz.Bottle20 min.Purple50 in·lbf-65° F to 300° FThin Liquid1,200 cP24 hr.000000000000
     
    back to top