Resistant to mold and mildew, these sealants are well suited to high-humidity environments.

Use these coatings on tanks to create a low-friction lining that prevents bubble formation and turbulence in the liquids within.

Made with Viton® fluoroelastomer, use these coatings to create a flexible coating on rollers, heavy equipment, and anything else that’s exposed to corrosive chemicals or extreme temperatures.

Longer-lasting than antislip tape, these coatings contain grit to provide traction. They’re good for areas with pedestrian traffic.

Put a temporary dull finish on glossy surfaces. Wipe to remove.

To effectively dissipate heat in the tightest spaces, this coating contains a filler that acts like a shim to produce a consistent 0.005" to 0.006" gap between components.

These coatings require an ultraviolet curing lamp to reach full strength.

Clear enough to read through, this coating allows optimal light transmission for use with LEDs, solar cells, and fiber optics.

Clear enough to read through, this UV-resistant potting compound allows optimal light transmission for use with LEDs, solar cells, and fiber optics.

Hot-melt potting compounds have excellent flexibility, good chemical and moisture resistance, and withstand a range of temperatures. They provide good electrical insulation.

Clear enough to read through, these UV-resistant potting compounds allow optimal light transmission for use with LEDs, solar cells, and fiber optics.

Formulated to draw heat away from sensitive electronic components, these potting compounds have higher thermal conductivity than standard potting compounds.

Protect sensitive electronic parts, enclosures, and prototypes from electromagnetic interference (EMI) with these coatings.

These primers have excellent adhesion to plastic. Use them to prepare your surface to extend the life of paint and coatings.

Use these primers in enclosed occupied areas, such as hospitals, schools, and offices. They cover stains and prepare your surface, extending the life of paint and coatings.

Made of rubber and iron oxide, these sheets can be cut with scissors to create custom-shaped nonmetallic, nonmagnetic surface that magnets will stick to.

Remove silicone, foam sealants, caulk, wet or dry latex-based foams, and construction adhesives.