Designed for use on hoppers, chutes, and pumps, these coatings protect against impact and abrasion. Thicker than paint, they resist UV, moisture, and chemicals. Apply with a brush, roller, or sprayer. The size listed is the combined total of the two parts.

Primers cannot be sold to Canada due to regulatory limits on VOCs (volatile organic compounds).

Made with Viton® fluoroelastomer, use these coatings to create a flexible coating on rollers, heavy equipment, and anything else that’s exposed to corrosive chemicals or extreme temperatures. Coatings resist acids, alkalies, fuels, and solvents, as well as temperatures as low as -40° F once cured. They can also be used as an adhesive for Viton® gaskets, O-rings, and seals.

Apply coatings in a bottle and can with a brush or roller. The size listed is the combined total of the two parts.

These coatings meet UL 723 and are rated Class A by ASTM E84—the highest rating available—for their ability to limit the spread of flames and generation of smoke. Use them in kitchens, furnace areas, and ships on plastic, metal, wood, and masonry. Apply with a brush, roller, or sprayer. The size listed is the combined total of the two parts.

Clear coatings are frequently used on wood—use one coat on sealed wood and two on unsealed. They can be used outside without breaking down, but prolonged exposure to UV light may cause them to yellow.

White coatings are frequently used on walls, ceilings, doors, and stairwells.

Longer-lasting than antislip tape, these coatings contain grit to provide traction. They’re good for areas with pedestrian traffic.

Water-based epoxy coatings are clear and can be applied over nearly any surface, even old coatings, without altering their appearance. These two-part coatings come with a mixer that attaches to a hand-held drill and a roller cover to apply them once mixed. The size listed is the combined total of the two parts.

Apply gallon-sized water-based coatings with a roller. Coatings that comply with OSHA 29 CFR 1910.22 meet requirements for walking-working surfaces.

Clear enough to read through, this coating allows optimal light transmission for use with LEDs, solar cells, and fiber optics. Thinner than potting compounds, it flows easily into small spaces between electrical components. The coating requires an ultraviolet curing lamp to reach full strength. Dispense with a gun (sold separately).

No mixing required --these potting compounds come ready to apply. Use them to encase electronic assemblies for protection from dust, moisture, mechanical shock, and vibration. Softer and more flexible than epoxies and urethanes with the widest temperature range, silicone potting compounds are the best choice for high-temperature applications and electronics exposed to thermal cycling. They have good moisture resistance but poor chemical and abrasion resistance. Silicones provide excellent electrical insulation. They're also known as RTV (room-temperature vulcanizing).

Potting compounds that cannot be sold to California exceed local regulatory limits on VOCs (volatile organic compounds).

Encase electronic assemblies in a layer of epoxy for protection from dust, chemicals, moisture, mechanical shock, and vibration. The strongest of the potting compounds, epoxies are rigid and wear resistant. They have excellent chemical and moisture resistance, withstand a wide range of temperatures, and provide excellent electrical insulation. All require a mixer nozzle and gun to dispense.

Reflect at least 85% of the sun's rays to reduce cooling costs. These coatings also restore and reinforce your roof by filling cracks and forming a water-resistant seal. Apply to a dry surface with a brush, roller, or sprayer.

Primer (sold separately) extends the life of the coating. It’s required for use on bare rubberized and aged asphalt roofs.

These silicone-based coatings renew leather and vinyl surfaces and protect against UV damage, dirt, and ozone. Spray them on, allow them to sink in, and buff away excess with a cloth.