System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter | Show |
---|
|
For Shaft Diameter For Shaft Diameter | Hide |
---|

For Motion Type For Motion Type |
---|
![]() | Rotary |
For Use With For Use With |
---|
For Sealing For Sealing |
---|
![]() |
Shafts |
Maximum Speed Maximum Speed |
---|
|
Material Material |
---|
|
Loader Type Loader Type |
---|
![]() | Spring |
Reinforcement Type Reinforcement Type |
---|
|
Case Material Case Material |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Hardness Hardness |
---|
|
Hardness Rating Hardness Rating |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
Spring-Loaded Rotary Shaft Seals with Wiper Lip



Used to retain oil on rotating shafts in motors, pumps, bearings, and gearboxes, these seals have a secondary lip that blocks contaminants. Also known as oil seals, a spring secures the lip against the shaft, preventing messy leaks. Press-fit seals into the bore around the shaft. Seals with a maximum pressure of 50 psi should be secured with a retaining ring.
Note: Maximum performance values cannot be achieved simultaneously; for example, speed is affected by pressure, temperature, and other operating conditions.
For technical drawings and 3-D models, click on a part number.

For Bore | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Dia. | Min. Wd. | Max. Speed, rpm | Max. Pressure, psi | Temp. Range, °F | Hardness | Color | Specifications Met | Each | |
Buna-N Rubber with Steel Case and Spring | ||||||||||
5/16" | 0.750" | 0.272" | 900 | 50 | -40° to 210° | Durometer 80A (Hard) | Black | DIN 3760, ISO 6194 | 0000000 | 00000 |
Rotary Shaft Seals for Grease



Also known as grease seals, these are designed to retain thick lubricant at low pressure in motors, pumps, bearings, and gearboxes. They have a light grip on the shaft that creates less friction than spring-loaded seals. Press-fit seals into the bore around the shaft.
Seals with an acrylic-coated case have a coating that compensates for surface imperfections in the housing bore for a tight seal on the OD.
Note: Maximum performance values cannot be achieved simultaneously; for example, speed is affected by pressure, temperature, and other operating conditions.
For technical drawings and 3-D models, click on a part number.

For Bore | Case | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Dia. | Min. Wd. | Max. Speed, rpm | Max. Pressure, psi | Temp. Range, °F | Hardness | Color | Finish | Color | Specifications Met | Each | |
Buna-N Rubber with Steel Case | ||||||||||||
5/16" | 0.626" | 0.172" | 900 | 10 | -40° to 210° | Durometer 75A (Hard) | Black | Acrylic Coated | Green | DIN 3760, ISO 6194 | 0000000 | 00000 |