Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

These metal collars are stronger than plastic shaft collars.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

A threaded lever lets you tighten these collars with more torque than other quick-release styles, ensuring that they stay put on your shaft.

These collars have one knurled side that lets you adjust their width.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Three tapped counterbored holes and three through-holes provide mounting flexibility.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

With a nylon insert that grips your threaded shaft or spindle without damaging the threads, these locknuts—sometimes called shaft nuts—keep bearings, bushings, gears, and pulleys in place.

Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

One end has a finished bore size; the other can be machined to any size—great for connecting to uncommon shaft sizes and shafts that are undersized from wear or oversized from coatings.

Set screws bite into your shaft to hold these couplings in place.

Machine the pilot hole in these couplings to whatever size you need. Often used for shafts that are undersized from wear or oversized from coatings. These couplings are two-piece, so you can remove and reinstall them without moving your shafts.

When your shafts are not close enough to use standard couplings, these have the length to bridge the gap.

Access one shaft without disconnecting the other. These rigid couplings have a solid bottom that connects the shafts and two top pieces that clamp the shafts independently.