Install these shaft covers on gear boxes, face-mount motors, and other areas where rotating shafts are exposed to protect the shaft from debris and prevent injury. When installed properly, they help comply with ANSI B11.19-2010 machinery guard standards.

These fiberglass bellows withstand temperatures up to 450° F—about twice as much as standard breathable round bellows with flange ends. They also protect against flames and sparks.

Thinner than other round bellows with cuff ends, these flexible bellows are meant for light duty applications.

Add cuff inserts to these flexible bellows for a custom fit.

Sewn seams let these bellows breathe, so they retract quickly in fast-cycling applications.

Attach the cuff end with a hose clamp and screw mount the flange end.

Slide these bellows over flat moving surfaces on machinery, such as guideways.

These bellows withstand temperatures up to 500° F—more than twice as much as standard flat bellows.

Attach the cuff end with a hose clamp, and screw mount the flange end.

Attach the cuff end with a hose clamp, and screw mount the flange end.

Guard 9" and 12" travel Bridgeport milling machines by covering their rear knee/upper column and front knee.

Slip these bellows over hydraulic cylinder rods to keep them free from debris for a long service life.

Also known as lift table skirts, these bellows cover the working parts at the base of a lift table.

Shield ball joint rod ends to keep lubricants in and contaminants out.

Slide these protectors over gas springs to keep debris out of their seals.