Use these general purpose shafts with bearings, sprockets, and gears to transmit rotary motion.

Also known as mild steel, low-carbon steel is easy to machine, form, and weld. It's widely fabricated into parts that don’t require high strength.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

These rods, also known as drill blanks, have an undersized diameter for machining your own jobbers'-length drill bits.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in your lathe.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

The most formable brass we offer, 260 offers better weldability than 300 series brass but it’s not as machinable. Sometimes called cartridge brass, it's commonly used for ammunition casings, radiator components, and decorative door hardware.

Offering high electrical conductivity and formability, 110 copper is 99.9% pure. Also known as ETP copper, it's often used in electrical applications, such as for bus bars and wire connectors, as well as for flashing, gaskets, and rivets.

Use these metal dowel pins as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Grooves run the full length of these pins for a firm hold that won't spin. Use them in place of standard dowel, spring, and taper pins to fasten parts. Also known as type A pins.