Plastic pins are a nonconductive and nonmagnetic alternative to metal dowel pins. Use them as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Cut this 12" stock to the length you need.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Grooves run the full length of these pins for a firm hold that won't spin. Use them in place of standard dowel, spring, and taper pins to fasten parts. Also known as type A pins.

These pins are commonly used as anchors for tension springs. The grooved half locks pins in position, and spring ends fit in to the notch. Also known as type G pins.

Grooves hold these pins in place, and a round head gives them a finished appearance.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

Join two pieces of wood with these dowel pins. When glued, they expand for a tight fit.

Pass wires and other components through these hollow pins.

Barbs bite into plastics and soft metals such as aluminum for a strong hold, and a round head gives a finished appearance.