McMaster-Carr logo
    Clear All
    System of Measurement
    System of Measurement
    Inch
    For Shaft Diameter
    For Shaft Diameter
    1/2"
    5/8"
    3/4"
    1"
    1 1/4"
    1 1/2"
    2"
    Material
    Material
    Show
    Iron
    Component
    Component
    Flange Nut
    Handle
    Nut
    Wing Nut
    Center Height
    Center Height
    default
    1"
    1 1/4"
    1 1/2"
    1 3/4"
    2"
    2 1/2"
    Nut Type
    Nut Type
    Flange
    Round
    Thumb
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    Fabrication
    Fabrication
    Cast
    Mounting Hole Center-to-Center
    Mounting Hole
    Center-to-Center
    1 1/2"
    1 7/8"
    2"
    2 1/16"
    2 1/2"
    3"
    3 1/2"
    4 1/2"
    Thread Direction
    Thread Direction
    click to learn more about
    click to learn more about Right Hand
    click to learn more about Left Hand
    Right HandLeft Hand
    Hardness Rating
    Hardness Rating
    Medium
    Hard
    Thread Type
    Thread Type
    click to learn more about
    Handle Style
    Handle Style
    BallOffset
    Flat
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Tolerance Rating
    Tolerance Rating
    Tight
    Oversized
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    214 Products