A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.

More corrosion resistant than 18-8 and 410 stainless steel threaded rods, these 316 stainless steel rods have excellent resistance to chemicals and salt water.

These acetal threaded rods won't absorb moisture like nylon and fiberglass rods, so they're good for use in wet environments. They resist alcohol, gasoline, and solvents.

Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

These steel studs are zinc plated to resist corrosion in wet environments.

316 stainless steel studs have excellent resistance to chemicals and salt water.

Pass these studs through a hole and weld them in place.

These studs have good chemical resistance. Weld them to stainless steel surfaces.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Similar to turnbuckles, these rods have right-hand threads on one end and left-hand threads on the other so you can make a linkage that adjusts for tension.