Connect these internally threaded shafts directly to threaded components, or use a fastener to secure. They have a flat surface area that allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Thread these shafts into a tapped hole to support idler sprockets and pulleys in tensioning applications. They have a retaining-ring groove, retaining ring, and spacers to position your component and hold it in place.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.

18-8 stainless steel threaded rods have good chemical resistance.

Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

These hardened 316 stainless steel threaded rods are 40% stronger than standard Grade B8M threaded rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Made from nylon 6/6, these threaded rods resist oil, grease, and solvents. They’re nonconductive, making them good for use around sensitive electrical components.

PVC threaded rods resist acids, alkalies, salt solutions, and alcohol.

These acetal threaded rods won't absorb moisture like nylon and fiberglass rods, so they're good for use in wet environments. They resist alcohol, gasoline, and solvents.

One-third the weight of steel, aluminum threaded rods resist corrosion in wet environments.

Bronze threaded rods are stronger and more resistant to salt water than brass rods.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

18-8 stainless steel studs have good chemical resistance.

These studs have good chemical resistance. Weld them to stainless steel surfaces.

18-8 stainless steel studs have good chemical resistance and may be mildly magnetic. Also known as hanger bolts, use them to hang, mount, and fasten parts to wood structures.

316 stainless steel studs have excellent resistance to chemicals and salt water.

A hollow center allows these studs to be used as an axle, a vent, or a passageway for wiring.

Attach a ball knob to one of these shafts to create custom handles for operating machinery.