Email Us

A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Attach threaded accessories, such as mixer propellers and fan blades, to the end of these shafts.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. About half the strength of medium-strength steel threaded rods, use them for light duty hanging, mounting, and fastening.

More corrosion resistant than 18-8 and 410 stainless steel threaded rods, these 316 stainless steel rods have excellent resistance to chemicals and salt water.

One-third the weight of steel, aluminum threaded rods resist corrosion in wet environments.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

18-8 stainless steel studs have good chemical resistance.

Weld these studs to uncoated steel surfaces.