For a long-lasting cutting edge that's three times harder than uncoated stainless steel, the blades on these scissors are titanium bonded over stainless steel.

Minimize hand fatigue with a lightweight handle and spring-action that automatically opens the blades for quick repeat cuts.

Longer handles and shorter blades give you more leverage than other scissors to cut tough materials such as leather, rope, and thick cardboard.

Blades are titanium bonded over stainless steel for a sharp, long-lasting cutting edge, and they have narrow, sharp tips for fine cutting and trimming.

Blades are ceramic to stay sharp longer than metal blades.

Prevent snags and injury with the rounded points on these small scissors.

For extra leverage to cut through Kevlar, metal, and plastics, these scissors have long handles and short blades.

A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

This cutter has two blades that cut a 13/64" wide strip—peel it back for smooth edges with little distortion.

These cutters make straight cuts and curves.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.

Handles are angled to keep your hand away from the material as you cut straight lines and curves.

A double blade creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Punch small pieces out of material to create an almost burr-free cut with no material distortion.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Also known a scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut metal up to 1/64" thick with minimal material loss and edge distortion.

Make straight, clean cuts in thick sheet metal.

This large-capacity cutter has a 25" blade for long, straight cuts.

Combine the cutting base and a corner punch to make rounded corners in sheet metal.