Keep your hand away from the material being cut.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

Make straight and curved cuts in sheet metal—these sets come with three tools for different cutting patterns. Also called aviation snips, they have a double hinge, so they cut with more force and require less effort to squeeze the handles than standard sheet metal cutters.

Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Replace blades as they wear. These cutters are also known as tinners' snips.

Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.

Use to cut patterns in flat material with minimal material loss and less effort compared to manual cutters.

Minimize material loss and edge distortion with these scissor-like cutters that cut metal up to 1/64" thick.

These nibblers punch small pieces out of material to create an almost burr-free cut with no material distortion.

Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut metal up to 1/64" thick with minimal material loss and edge distortion.

Move these lightweight cutters wherever you need to make clean, straight cuts through metal.

Notch, cut, and pierce a variety of materials including metal, plastic, and vinyl.

Cut armored cable such as BX, HCF, and MC and flexible metal conduit.

Minimize wire distortion when cutting 11/16" diameter and larger aluminum and copper power and communication cable.

Jaws ratchet to increase cutting pressure as you open and close the handles.

Shaped like tweezers, these cutters make accurate, flush cuts in small wire without damaging the surface underneath. The grips drain static away from the tips, protecting sensitive components from electrostatic discharge (ESD).

Made of stainless steel, these cutters won’t rust even when stored in damp environments. The grips drain static away from the blades to prevent damage to sensitive equipment from electrostatic discharge (ESD).

Snip wire close against circuit boards and other electronic components without building up electrostatic discharge (ESD).

Cut thin, hard wire with these small cutters.