A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

Snip tighter curves in smaller spaces than standard high-force cutters.

Also known as tinners' snips, these cutters make straight cuts and curves.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

The unique shape of these cutters gives you 40% more power per cut than standard sheet metal cutters. When blades get dull, loosen a few screws to replace them.

Sized and shaped like pliers, these sheet metal cutters are small enough to fit in your tool belt.

Use to cut patterns in flat material with minimal material loss and less effort compared to manual cutters.

Punch small pieces out of material to create an almost burr-free cut with no material distortion.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Make straight, clean cuts in thick sheet metal.

Turn your workpiece while cutting to create curves and complex shapes.

Leave clean cut edges in a variety of pliable materials.

Shaped like tweezers, these cutters make accurate, flush cuts in small wire without damaging the surface underneath. The grips drain static away from the tips, protecting sensitive components from electrostatic discharge (ESD).

Cut thin, hard wire with these small cutters.

Cutters have double hinge that provides high cutting force with low gripping pressure.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

With a quick hammer blow, these cutters make cuts without squeezing or flattening wire.

These manually operated cutters make a clean cut with just a few pumps of the handle.

Keep one hand free while cutting and trimming strapping.