Made of aluminum with a fiberglass liner, this sleeving reflects heat away from contents and withstands temperatures up to 390°F. A slit along the entire length makes it easy to install around wire, cable, and hose without disconnecting them.

Also known as FMC, this conduit offers the crush resistance of metal combined with flexibility to handle bends in tight spaces.

Join pieces of conduit.

These enclosures reduce electromagnetic interference (EMI) and radio frequency interference (RFI), which can cause electrical problems like flickering monitors, interrupted data signals, and unwanted radio noise.

These enclosures have thicker walls than standard aluminum enclosures, but are still a lightweight yet durable alternative to stainless steel.

Choose a body and two matching end caps to make your own dust-tight or watertight enclosure.

Aluminum enclosures are a lightweight yet durable alternative to stainless steel.

For use in hazardous locations, these enclosures are rated NEMA 7 and 9 and meet UL Class I, Divisions 1 and 2, Groups B, C, and D; Class II, Divisions 1 and 2, Groups E, F, and G; and Class III, Divisions 1 and 2.

Lighter than stainless steel yet durable, these aluminum enclosures protect electronics from frequent washdowns and withstand periodic submersion in water.

Snap these enclosures onto 35 mm DIN rail and lock them in place.

Protect personnel and equipment from debris with these portable panels.

Also known as hospital-grade outlet strips, these outlets have an extra-tight fit to prevent plugs from detaching. They are marked with a green dot.

Separately control each device plugged into these strips—each outlet has its own power switch.

Install these extra-long strips onto the frame of an electrical cabinet.

Protect screw-together M12 connectors when not in use.

3000 series aluminum stands up to outdoor use, as well as exposure to chemicals. It offers a good combination of strength, formability, and weldability. It's often used for storage tanks, heat exchangers, garage doors, and general sheet metal work.

Made of 1000 series aluminum which is 99% pure, this aluminum offers superior formability, corrosion resistance, and electrical conductivity. It's frequently fabricated into raceways, decorative trim, and other parts where strength and hardness are not required.

These metal guards provide more impact protection than plastic guards. Commonly used in warehouse and manufacturing areas, they protect corners on walls and other surfaces from impact.

Fortify a door's base as well as its bottom edge to guard them against damage from foot traffic and equipment. These plates can also be used to salvage rusted, rotted, or otherwise damaged doors.

Also known as door plates, armor plates, and mop plates, kick plates protect the base of a door from damage caused by foot traffic and equipment.

This polyester tape has a woven mesh edge that conducts electricity. Use it to shield cables and electronic components from EMI (electromagnetic interference).

Use this tape to attach components to heat sinks and metal chassis walls in place of screws and other mechanical fasteners. It conducts heat away from sensitive electronics.

Cover small spots and holes while paint stripping and electroplating, or use as a moisture and dust barrier. These aluminum foil discs are flexible and conform to irregular shapes.

Control the unwanted noise that comes from vibrating panels and support structures. This aluminum foil tape reduces vibration by converting it into a small amount of heat.

Reinforced with fiberglass, this tape is flexible yet resists tearing. Use it for sealing and patching insulation and duct.

Seal foil-jacketed insulation as well as air-conditioning and refrigeration systems with this conformable aluminum tape.

Seal tube and hose fittings to keep their straight threads protected from contaminants during fabrication and storage.

More durable than plastic plugs, these provide the most protection from abrasion and impact. Use them to eliminate sharp edges and create a finished look on metal fence and machine-guard posts. Drive them in place with a hammer for a secure fit.

Protect externally threaded components from contaminants during fabrication and storage.