When speed and accuracy matter most, opt for these bearings. They’re made to tighter tolerances than standard flanged ball bearings.

Install these acetal bearings in caustic environments and where lubrication can’t be used. They have good all-around corrosion and chemical resistance.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

The oil in these bearings is suitable for incidental contact with food.

Good for underwater applications, these bearings won’t swell or warp when wet.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

An aluminum shell adds strength.

Graphite provides a layer of dry lubrication that operates in high-temperature environments.

The addition of iron and aluminum gives these aluminum-bronze bearings high strength and excellent corrosion resistance—making them suitable for use in marine and mining applications.

Use these bearings for light loads and small shafts. The closed backing blocks out dust and other contaminants.

The lubricant in these mounted ball bearings is suitable for incidental contact with food.

Synthetic grease enables these bearings to operate in temperatures up to 400° F—nearly double the maximum temperature of standard mounted ball bearings with two-bolt flange.

Embedded particles of PTFE increase the load capacity of these bearings while also making them slippery.

Made of FDA listed PEEK, these bearings are suitable for direct contact with food. The closed backing blocks out dust and other contaminants.

Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface.

Synthetic grease enables these bearings to operate in temperatures up to 400° F—nearly double the maximum temperature of standard mounted ball bearings with four-bolt flange.

A bold in each corner makes for a secure, even hold.

Use these bearings in corrosive environments and under water.

The shell, housing, and balls of these bearings are stainless steel for excellent corrosion resistance.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.