A silicon carbide coating over a carbon foam base combines the hardness, chemical resistance, and high temperatures silicon carbide is known for with the lightweight versaitility of foam. It’s often used for cores in composite layers and to filter molten metals and corrosive liquids.

Create bushings and other parts that will be exposed to abrasion, harsh chemicals, high heat, and rubbing with these rods. Sintering strengthens the bonds within silicon carbide, leaving it two times stronger than other versions of silicon carbide.

Over 99% pure, these rods have the strength of silicon carbide throughout, so they resist deforming under heavy loads at high temperatures (known as creep). They’re often used as supports in kilns.

Machine these rods into nozzles for acids, pins or supports for kilns, and other parts that require extreme hardness when exposed to quick temperature changes and chemicals. This nitride-bonded silicon carbide is better at transferring heat than most ceramics and expands without cracking when temperatures fluctuate.

This film abrades quickly and prevents material buildup.

These cut-to-length rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding. A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface.

A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface. These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Providing the control of a sanding block while remaining flexible, these sponges sand around curves and in corners.

Sized for tight spaces, these small pads sand flat and curved surfaces. They have a flexible foam layer that gives you more control over sanding pressure, creating finer and more consistent finishes.

A coating prevents dust and debris from building up on the abrasive surface.

Cut to convenient sizes and shapes, these fit most sheet sanders.

The mesh backing lets sanding dust and debris escape during use, preventing material build up on the abrasive surface.

The rubber backing cushions the abrasive to prevent gouging your aluminum, soft metal, and nonmetal work surfaces.

A different grit on each side enables multistep sharpening with one stone.

The reservoir in the base keeps the stone clean and oiled.