Good for electroplating, paint baking, and powder-coating applications, these plugs withstand temperatures up to 570° F. All are tapered to fit a range of hole diameters.

Place a plug into an opening and tighten the wing nut—the sides expand to create a seal in holes of varying diameters. Good for paint baking and powder-coating applications, these plugs withstand temperatures up to 450° F.

These plugs withstand temperatures up to 600° F to protect internally threaded NPT connections from contaminants during electropainting, paint baking, and powder coating applications.

Designed with a flange, these plugs protect countersunk holes during anodizing, electroplating, paint baking, and powder-coating applications. All withstand temperatures up to 600° F. Use the smaller end of the plug to pull the larger end into a through hole to form a tight seal.

Good for electroplating, paint baking, and powder-coating applications, these caps withstand temperatures up to 440° F or 570° F.

These bumpers withstand temperatures up to 300° F, which is twice as high as our other load rated bumpers. Use them in applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, these bumpers absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist them into a threaded hole.

Push the stem into a hole for quick installation. These bumpers are commonly used as feet on instruments and bench-top equipment to keep them from sliding. They're also good as spacers between sheets of material. Also known as stem and grommet bumpers.

These flexible grommets withstand temperatures of 450° F or greater, which is approximately twice as high as our standard grommets. Push them into place to protect wire, cable, and cords by turning rough-edged and uneven holes into smooth, insulated holes. Commonly used in metal panels, they also damp vibration.

This trim withstands temperatures up to 450° F, which is generally twice as high as our standard rubber trim. Use it to protect the edges of panels, boards, and signs from impact. Made of rubber, it resists abrasion better than plastic trim.

A two-piece design makes these mounts easier to install than one-piece mounts.