We will reply to your message within an hour.
Brass makes these spacers electrically conductive and the zinc-plated finish adds corrosion resistance.
Choose the OD, ID, length, and material and we will accommodate your unique spacer needs.
Position components in assemblies, as well as separate or connect parts with these standoffs.
The magnetic end of these standoffs makes it easy to temporarily mount or reposition components on magnetic surfaces.
Often called swage standoffs because you permanently crimp them into a panel.
Brass coupling nuts are corrosion resistant in wet environments and electrically conductive.
A nonconductive rubber coating insulates the nut from electricity, seals out moisture, and damps vibration.
Add length to a binding barrel.
Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.
Made from brass, these inserts are electrically conductive, nonmagnetic, and have good corrosion resistance.
Made from brass, these inserts are nonmagnetic, corrosion resistant, and electrically conductive.
The flange keeps these inserts from pulling through a hole. Press them in from the underside of material, and install a screw from the top of material.
Use these inserts to install fine-thread screws in existing holes.
The barbed sides keep these securely in place even before a screw is installed.
Push down on the inside of these inserts with an installation tool and they expand to hold firm in surrounding material.
The tapered shape makes it easier to guide these inserts into a hole during installation. Use a drill bit to create a straight hole, then taper the top half.
Assortments include various sizes of inserts, a soldering iron, a ceramic insulation tube, and installation tips.
Install these inserts into plastic parts to create a secure base for fasteners.
With the male threaded end on these inserts, mount components directly to plastic parts.
Also known as Trisert inserts, these cut threads into plastic and have better holding power than press-fit inserts.
Made from brass, these inserts are nonmagnetic, mildly corrosion resistant, and electrically conductive.
Assortments include various sizes of tapping inserts for hardwood.
Use these sleeves with compression nuts and fittings to create a strong seal on copper tubing.
Create a strong seal on copper tubing when you couple these nuts with compression sleeves and fittings.
Use ferrules to create a permanent connection between your air- and water-hose and barbed hose fittings.
Create a permanent connection between your welding hose and barbed hose fittings.