18-8 stainless steel spacers have good corrosion resistance.

The zinc plating provides some corrosion resistance.

Brass makes these spacers electrically conductive and the zinc-plated finish adds corrosion resistance.

Choose titanium spacers for their high strength-to-weight ratio and excellent corrosion resistance.

Almost nonabsorbent, these unthreaded LDPE and HDPE spacers won't swell when exposed to water.

Naturally slippery and wear resistant, acetal spacers also offer some resistance to moisture.

Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.

Reduce vibration, shock, and noise with these spacers that compress between components.

With their mirror-like finish, these are the go-to spacers when appearance matters.

Protect components from electrical charges.

The 45° end fits against an angled surface to create a flat surface for connection.

Protect components from electrical charges.

Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.

These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.

Often called swage standoffs because you permanently crimp them into a panel.

In enclosures and other places where you don’t want to drill a hole, mount circuit boards and other thin panels with these supports.

With the end clinched in place, the prongs allow you to quickly snap a panel on and off these supports.

Both ends snap and lock in place for a permanent connection.

The ends of these removable supports snap in and compress between panels to reduce vibration of miniature cooling fans in compact electronics.

Thinner than other round bellows with cuff ends, these flexible bellows are meant for light duty applications.

Made of FDA listed materials, these rigid bellows are suitable for food and beverage applications.

Suitable for tight spaces, these highly compressible bellows have sealed seams to keep contaminants out.

No need to disassemble equipment—these bellows wrap around moving parts. Sewn seams let them breathe, so they retract quickly in fast-cycling applications.

Interlock bellows, mounting flanges, and links to create a custom-length bellows. These molded bellows are airtight to keep contaminants out.

Install these bellows over gas springs to protect their piston rods.

Protect U-joints to keep lubricants in and contaminants out.

Create a tight seal around wire, cable, and cords with these grommets to keep out dust, debris, and moisture.

Cut the center of these grommets with a utility knife to create custom IDs. The two‐piece design makes it easy to install and seal these grommets around wire, cable, and cords that are already in place. Use them to keep out dust, debris, and moisture.

Rated IP68, these grommets form liquid-tight seals around wire, cable, and cords to protect them against dust as well as submersion in a maximum of one meter of water.

These flexible grommets withstand temperatures of 450° F or greater, which is approximately twice as high as our standard grommets. Push them into place to protect wire, cable, and cords by turning rough-edged and uneven holes into smooth, insulated holes. Commonly used in metal panels, they also damp vibration.