Made of recycled UHMW plastic, these sheets and bars are an economical, environmentally friendly alternative to standard UHMW while still offering the same low-friction surface that prevents sticking and binding.

Made with carbon black, these recycled UHMW sheets are a sustainable alternative to standard UHMW sheets in applications where static electricity is a concern, such as in conveying equipment and chute liners.

This oil-filled material is self-lubricating for an extra-slippery surface.

Compared to our standard UHMW polyethylene, these sheets and bars hold up better to scuffs and scrapes in high-speed, high-precision, and high-impact applications—such as conveyor equipment, chute liners, and machine guards. Also known as Tivar HPV.

If a chip of this material breaks off, it can be located by metal detectors to reduce contamination risks.

This material prevents the buildup of static charges.

Delrin® acetal resin, also known as acetal homopolymer, is stronger and stiffer than acetal copolymer.

Designed for extreme wear resistance, this Kevlar-filled nylon 6/6 material lasts up to 20 times longer than unfilled nylon. Also known as Hydlar Z, it is often used for parts that are continuously exposed to wear and abrasion, such as wear strips and bushings.

Because this 6/12 material absorbs less water than standard nylon 6/6, it holds its shape better. It’s often machined into hose fittings and valve components.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

Often used to make gears and wear strips, these cast nylon 6 sheets and bars withstand higher temperatures and are easier to machine than standard nylon 6/6 sheets and bars.

Known for its naturally slippery surface, PTFE surpasses most plastics when it comes to chemical resistance and performance in extreme temperatures.

Manufactured from Rulon PTFE, a PTFE material that's modified with epoxy-coated fiber for a super-slippery, impact-resistant surface that resists wear.

Common in food and pharmaceutical plants, these PEEK sheets and bars help you identify contaminated batches.

Just as chemical resistant as PTFE, yet FEP offers greater impact strength. Use it to make valve components and gaskets.

These bars are precision ground on the top and bottom for a tight thickness tolerance of ±0.002".

This material is hardened for increased wear resistance over standard 420 stainless steel.

One of the most machinable types of stainless steel available, 416 contains sulfur for fast machining without clogging cutting tools. It's used for gears, screws, and shafts.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

The width and thickness are oversized for finishing to your exact requirements.

These sheets have a softened temper, which is also known as annealed, so they can be easily formed into shape and then heat treated for spring properties.

The thickness, length, and width are oversized for finishing to your exact requirements.

Suitable for food contact, these plates are made of FDA listed UHMW plastic, which has a slippery surface to minimize friction. Often found on conveyor systems, use these plates where friction between two parts or materials is wearing down equipment to extend equipment life.