The stacked design provides stability for deep and wide drawers.

A lever locks the drawer in the open as well as closed position; push the lever to release the lock.

These slides provide full extension for convenient access to the back of your drawers.

These slides automatically pull the drawer closed when it approaches the closed position.

A stop holds the drawer open; push firmly on the drawer to close.

To prevent drawers from slamming shut and support them even if they’re tall and full of heavy equipment, these steel slides have soft-closing bumpers and mount to the top and bottom of drawers.

Mount these slides underneath countertops, desktops, shelves, and tables. They are often used to hold keyboard trays.

These complete sets contain everything you need to create a system for hanging doors.

Round track eliminates edges where dust and debris can accumulate.

These sets include everything you need to hang two doors that slide past each other.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.

Lighter than solid shafts, hollow shafts reduce your total system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

With 2" of each end softened, it's easier to machine a custom end for mounting. The rest of the shaft is case-hardened, which increases hardness and wear resistance on the surface of the shaft while allowing the center to remain soft for absorbing stresses caused by shifting loads.

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.