System of Measurement
    System of Measurement
    Inch
    Metric
    Number of Flutes
    Number of Flutes
    23
    47
    911
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Individual/Set
    Individual/Set
    IndividualSet
    Flute Type
    Flute Type
    Spiral
    Straight
    Flute Spacing
    Flute Spacing
    Equal
    Variable
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Corner Cut Radius
    Corner Cut Radius
    0.015"
    0.02"
    0.03"
    0.045"
    0.06"
    Cutting Angle
    Cutting Angle
    60°
    82°
    90°
    Taper Angle per Side
    Taper Angle per Side
    1 1/2°
    10°
    Number of Pieces
    Number of Pieces
    3
    6
    Container Type
    Container Type
    Wood Case
    Wood Stand
    Plastic Case
    For Maximum Hardness
    For Maximum Hardness
    Rockwell C52
    Rockwell C62
    Rockwell C70
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    2,095 Products