Use individual keyway broaches in a variety of arbor hole sizes. Bushings rest inside the arbor hole of your workpiece and act as guides to ensure rigid and accurate keyway cutting.

Also known as arbor spacers, these are notched to space components on a keyed shaft.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Customize the bore of these flexible couplings to align uncommon shaft sizes as well as shafts that have become undersized from wear or oversized from coatings.

Connect splined shafts to keyed shafts. These couplings are commonly used to connect hydraulic pumps, compressors, and other heavy duty equipment, which often have splined shafts, to electric motors and other components that often have keyed shafts.

When you need a strong hold and even grip on shafts that are oversized due to finishes, undersized from wear, or uncommonly sized, we’ll make a coupling for you that fits just right. These couplings clamp around your shafts to prevent marring them.

When one of your shafts is undersized from wear, oversized from coatings, or uncommonly sized, machine one end of these couplings to fit. They clamp around your shafts for a secure hold that won’t cause damage.

For hard-to-access shafts that are oversized from coatings or undersized from wear, we’ll get you a coupling in the right size that clamps on as two pieces, so you don’t need to move your shafts or installed components.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

Three tapped counterbored holes and three through-holes provide mounting flexibility.

These metal collars are stronger than plastic shaft collars.

Reduce the diameter of your shaft while adding length.