For applications with frequent starts and stops, the oil in these bearings contains particles of slippery PTFE that lubricate the bearing during startup.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Embedded with oil that is safe for incidental contact with food, these bearings are suitable for use in high-load applications such as bottling and filling lines in food processing plants. They are also known as Super Oilite® bearings. Startup friction releases the embedded oil onto their surface in a thin layer. Bearings are made of 863 iron-copper, which makes these bearings strong and resistant to shock loads.

Bearings with NSF H1 registered lubrication comply with NSF standards for incidental contact with food.

For technical drawings and 3-D models, click on a part number.

Use these bearings for frequent starts and stops in high-load applications. Startup friction causes these bearings to release a thin layer of oil that contains PTFE to lubricate the bearing’s surface. All have more iron content than standard oil-embedded bearings to handle heavier loads and higher shock loads, but operate at lower speeds.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Use where high loads and speeds are not required.

Thermoplastic-blend bearings have low moisture absorption and create very low friction in applications with light loads, and frequent starts and stops.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Rulon J bearings create the least amount of friction of any bearing that we offer. They handle heavier loads than PTFE bearings.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings. Bearings resist corrosion in outdoor and saltwater environments.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.