Made of aluminum, these spacers are lightweight and mildly corrosion resistant.

These spacers have excellent corrosion resistance and are passivated for enhanced protection.

Compared to our general purpose washers, these have exaggerated diameters and/or thicknesses. Use them to cover oversized holes, hold heavy fastening loads, or as spacers and levelers.

Also known as Type B washers, these distribute your fastener's load over a larger surface area than other washers to minimize damage to soft materials.

These metric washers surpass most other plastic washers when it comes to withstanding chemicals, oil, and grease.

Low moisture absorption and good heat resistance make these metric washers suitable for wet and harsh environments.

These metric washers hold up in blistering temperatures up to 3000° F.

Flat and oval head screws sit flush within these metric washers for a neat, finished appearance.

Reinforce holes in soft material to keep them from collapsing around screws.

Clipped to fit where standard washers can't, these won't rotate when you position the flat edge against a flat surface.

Designed for use with bearing nuts, these lock washers have a conical shape that presses like a spring against bearings, bushings, gears, and pulleys to hold them in place on your threaded shaft or spindle.

These washers have smaller outside diameters than standard spring lock washers to fit neatly under socket head cap screws.

The arched shape of these washers presses up against a bolt and down against a nut to prevent loosening from wear, vibration, or temperature changes.

Internal teeth dig into the screw head while the smooth outside edge won't snag objects. Use with metric fasteners that have small heads, such as fillister and cheese head screws.

The teeth on these washers bite further into the screw head and joint than standard external-tooth washers to provide a stronger hold.

The combination of internal and external teeth boosts gripping power to maintain a tight hold and provide more vibration resistance than other tooth lock washers. Use with fasteners that have heads large enough to make contact with the external teeth, such as pan, button, and binding head screws.

Sunlight, ozone, and water won’t affect these washers.

These washers surpass other rubber washers when it comes to withstanding oil, grease, and fuel.

These washers are rated to withstand pressure up to 100 psi.

With three points of surface contact, these washers provide more stability than single-wave washers.

Slide these shims under the screw head to shorten the shoulder length.