Replace worn screws or customize your clamps.

Attach cutoff wheels, grinding wheels, and other abrasive wheels to hand-held drills and die grinders.

The arbor’s shank attaches to hand-held drills and die grinders. Threads on the body hold the sanding roll in place.

The threaded head on these arbors holds a grinding cone.

Mount wheel brushes that have an arbor hole to hand-held drills and die grinders.

Adapt flap wheels with a threaded stud for use on tools that have a threaded spindle.

Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.

Mount cutoff wheels, grinding wheels, and other abrasive discs to the straight shaft on bench-top motors, grinders, and buffers.

Attach to grinder and buffer shafts to hold buffing wheels with shanks.

Use one of these spindles to mount buffing wheels to the tapered shaft on your grinder or buffer.

Slide a sanding sleeve on the drum and tighten the nut or screw to securely hold the sleeve.

Slide a flap sanding sleeve on the drum and twist the drum by hand to secure the sleeve.

Mount a sanding sleeve to the straight shaft of a bench or pedestal grinder using one of these drums.

Shape, debur, and sand edges and internal surfaces.

The premium abrasive stays sharp longer.

A coating prevents dust and debris from building up on the abrasive surface. These sleeves shape, deburr, and sand edges and internal surfaces.

Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.

The premium abrasive stays sharp longer.

No assembly required—these spools are all one piece. Use them to store twine, wire, rope, and chain.

Feed wire through the wheels inside the included counter to take measurements.