Interlocking teeth help these pins resist sliding when exposed to vibration. They have a slot that presses closed when the pins are inserted so they don't flex after installation.

For tough jobs, these spiral pins are 30% stronger than our standard coiled spring pins. They remain flexible after installation to absorb shock and vibration, and work well in holes that are out of round.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

The ring allows you to attach these spring plungers to a lanyard.

Use the lanyard as a tether to secure the spring plunger to machinery and prevent accidental drops.

Thread onto machinery or attach a knob or handle to the threaded spindle.

A T-handle makes these spring plungers easy to grip.

A smooth ball handle is easy to grip and won't catch on other parts.

An L-handle takes up less space than a T-handle.

Two holes in the plate allow these plungers to be mounted to a flat surface.

Insert the nose into a panel; then thread on the nut and tighten using an installation wrench.

Use an arbor press or similar pressure tool to install these spring plungers into a panel.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Install with a hex key for more torque than slotted long-nose spring plungers.

These spring plungers have a nose that is about three-times longer than standard long hex-nose spring plungers.

Designed with a flange to keep the plunger from being pushed through a hole when the ball is depressed.

An O-ring in the flange creates a tight seal.

Press these catches into a hole.

Coiled spring pins are flexible after installation, so they absorb shock and vibration better than slotted spring pins. They also have higher dynamic load capacities and accommodate wider hole tolerances.

The fastest way to install shallow-hole female-threaded anchors. Just push the tip of the tool into the anchor and turn the tool with a power drill.

Also known as caulk-in anchors, these stay secure when there's not much material to hold.

Often referred to as four-way expansion anchors, these expand in four directions to resist loosening from vibration.

These 18-8 stainless steel anchors have good chemical resistance.

Drive these tools with a hammer until the thicker portion of the tool makes contact with the anchor, causing it to expand.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

Turn the bolt to expand the nut for a secure hold in concrete. These anchors are often used to anchor machinery.

Sealed at the top to prevent debris from getting inside and making them seize up, these guide pins are a good choice for machining fixtures.

Threading makes these guide pins easier to remove and replace than press fit, so they're useful for high-wear applications.

As the face of these plungers is pushed in, the internal spring applies outward pressure to hold a workpiece in position against stops and rails.