Install with a driver.

Fasten from the nose end with a wrench for more torque than slotted long-nose spring plungers.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Lock the nose into the retracted position by pulling the handle and rotating it 90°.

The ring allows you to attach these spring plungers to a lanyard.

Use the lanyard as a tether to secure the spring plunger to machinery and prevent accidental drops.

Install by hand or with a hex key in low-clearance applications.

Use an arbor press or similar pressure tool to install these spring plungers into a panel.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

Install with a hex key for more torque than slotted ball-nose spring plungers.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

Also known as jam set screws, these lock other screws in place, hold pins, and adjust spring tension. A black-oxide finish provides corrosion resistance in dry environments.

A shallow head makes these bolts good for low-clearance applications.

A spring-loaded toggle holds against the back of the material.