System of Measurement System of Measurement |
|---|
|
Length Length | Show |
|---|
|
Length Length | Hide |
|---|
Spring Type Spring Type |
|---|
 |
| Compression |
 |
| Extension |
Material Material |
|---|
|
End Type End Type |
|---|
 | Hook |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Energy Capacity Energy Capacity |
|---|
|
Compressed OD @ Maximum Load Compressed OD@ Maximum Load |
|---|
|
Hardness Hardness |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Color Color |
|---|
 | Black |
Ultra-High-Load Fastener-Mount Compression Springs
For the heaviest loads, these springs have more than double the load capacity of High-Load Fastener-Mount Compression Springs. Secure by inserting a fastener through the hole at the base. Springs are a polyester/rubber blend that is wear, oil, and fuel resistant.
Energy is calculated in one of two ways. For an object that is dropped, energy equals the weight of the item multiplied by distance dropped. For an object moving horizontally, energy equals half of the mass of the item multiplied by velocity squared (1/2 mv²).
For technical drawings and 3-D models, click on a part number.
| Lg. | OD | ID | Base Dia. | Compressed Lg. @ Max. Load | Compressed OD @ Max. Load | Max. Load, lbs. | Energy Capacity, in.-lbs. | Mounting Hole Dia. (A) | Mounting Fasteners Included | Material | Hardness | Temperature Range, °F | Each | |
| 2.125" | 2.38" | 1.23" | 2.1" | 1.19" | 3.05" | 5,000 | 2,500 | 0.54" | No | Polyester/Rubber Blend | Durometer 55D | -40° to 120° | 0000000 | 000000 |
Extension Springs with Hook Ends
As you stretch an extension spring, it gets harder to pull. Minimum load is the amount of force required to start to extend the spring. Maximum load is the amount of force required to fully extend the spring. Rate is the amount of force required for every inch or mm of extension.
For technical drawings and 3-D models, click on a part number.
Load, lbs. | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| OD | Wire Dia. | Extended Lg. @ Max. Load | Min. | Max. | Rate, lbs./in. | Material | Pkg. Qty. | Pkg. | |
2.125" Lg. | |||||||||
| 0.75" | 0.105" | 2.639" | 12.8 | 50 | 72.35 | Spring-Tempered Steel | 6 | 0000000 | 00000 |
Corrosion-Resistant Extension Springs with Hook Ends
Made of stainless steel, these springs are more corrosion resistant than steel springs. They're also easier to extend than steel springs. As you stretch an extension spring, it gets harder to pull. Minimum load is the amount of force required to start to extend the spring. Maximum load is the amount of force required to fully extend the spring. Rate is the amount of force required for every inch of extension or, for metric springs, millimeter of compression.
302 stainless steel springs have good corrosion resistance.
For technical drawings and 3-D models, click on a part number.