Extra-Stretch Extension Springs


These fabric-covered rubber springs stretch up to three times their original length—much farther than traditional extension springs, tie downs, and shock cords. All have carabiner ends with spring-loaded latch openings. Do not use to hold overhead loads.
As you stretch an extension spring, it gets harder to pull. Minimum load is the amount of force required to start to extend the spring. Maximum load is the amount of force required to fully extend the spring. Spring rate is the amount of force required for every inch of extension.
Load, lbs. | Carabiner | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
OD | Extended Lg. @ Max. Load | Min. | Max. | Spring Rate, lbs./in. | Material | Sleeve Material | Lg. | Opening Wd. | Material | Temperature Range, °F | Each | |
42" Lg. | ||||||||||||
1" | 114" | Not Rated | 26 | 0.36 | Latex Rubber | Polypropylene Fabric | 2" | 5/16" | Black-Oxide Steel | 30° to 130° | 000000 | 000000 |
1.75" | 114" | Not Rated | 33 | 0.46 | Latex Rubber | Polypropylene Fabric | 2" | 5/16" | Black-Oxide Steel | 30° to 130° | 0000000 | 00000 |
1.75" | 114" | Not Rated | 47 | 0.65 | Latex Rubber | Polypropylene Fabric | 2" | 5/16" | Black-Oxide Steel | 30° to 130° | 0000000 | 00000 |
1.75" | 114" | Not Rated | 77 | 1.07 | Latex Rubber | Polypropylene Fabric | 2" | 5/16" | Black-Oxide Steel | 30° to 130° | 0000000 | 00000 |
Wear-Resistant 1095 Spring Steel Sheets and Strips

- Yield Strength: Not Rated
- Hardness: Rockwell C48-C51 (Very Hard)
- Fabrication: Cold Worked
- Specifications Met: ASTM A684
Also known as blue-tempered steel, this 1095 spring steel has a higher carbon content than 1075 spring steel for better wear resistance. It’s often used for spring clips, washers, and other parts that are under continual stress. These sheets and strips are hardened for increased abrasion and impact resistance. All meet ASTM A684 standards for performance and quality.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.
Wd. | Lg., ft. | Thick. Tolerance | Heat Treatment | Mechanical Finish | Color | Each | |
0.062" Thick. | |||||||
---|---|---|---|---|---|---|---|
10" | 3 1/2 | -0.002" to 0.002" | Hardened | Polished | Blue | 00000000 | 0000000 |