Clear All
Component Component |
|---|
 | Gear Stock |
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter | Show |
|---|
|
For Shaft Diameter For Shaft Diameter | Hide |
|---|
Gear Type Gear Type |
|---|
 | Spur |
Bore Type Bore Type |
|---|
 | Machinable |
Number of Teeth Number of Teeth |
|---|
|
Gear Pitch Gear Pitch |
|---|
Pressure Angle Pressure Angle |
|---|
|
Material Material |
|---|
|
Length Length |
|---|
|
Teeth Heat Treatment Teeth Heat Treatment |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
About Gears
More
Gear Rod Stock
Machine your own gears to fit the exact face width and shaft diameter required. Rod stock has teeth with a 20° pressure angle, the current industry standard. 20° pressure angle gears have thicker, stronger teeth than 14½° pressure angle gears. Teeth are not hardened so you can machine and harden them to fit your application. Hardening a gear’s teeth increases its wear resistance. Also known as spur gear rod stock.
For gears to mesh correctly, they must have the same pressure angle and pitch.
For technical drawings and 3-D models, click on a part number.
| Gear Pitch | Number of Teeth | Gear Pitch Dia. | OD | Lg. | For Shaft Dia. | Material | Each | |
| 12 | 24 | 2" | 2.17" | 1 ft. | 1/32"-1 3/32" | 1215 Carbon Steel | 0000000 | 0000000 |