System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter | Show |
|---|
|
For Shaft Diameter For Shaft Diameter | Hide |
|---|
ID ID |
|---|
|
Material Material |
|---|
|
For Shaft Angle For Shaft Angle |
|---|
 | 90° |
Component Component |
|---|
 | Gear |
Number of Teeth Number of Teeth |
|---|
|
Gear Pitch Gear Pitch |
|---|
Shaft Mount Type Shaft Mount Type |
|---|
|
Pressure Angle Pressure Angle |
|---|
|
Bore Type Bore Type |
|---|
 | Round |
Speed Ratio Speed Ratio |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Gear Type Gear Type |
|---|
 | Miter |
Bushing Type Bushing Type |
|---|
|
Gear Pitch Diameter Gear Pitch Diameter |
|---|
|
About Gears
More
Light Duty Sleeve Bushings
Reduce the ID of sprockets, pulleys, and gears in low-torque applications. Bushings have a hole for a set screw.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Overall Wd. | Set Screw Hole Dia. | Material | Each | |
| 7/16" | 1/2" | 1 1/8" | 3/8" | Steel | 0000000 | 000000 |
Metal Miter Gears
With straight, conically shaped teeth and a 1:1 speed ratio, miter gears connect two shafts at an angle without changing shaft speed or torque. They're more efficient than spiral miter gears because they create less friction.
For two gears to mesh correctly, they must have the same pressure angle, shaft angle, pitch/module, and number of teeth.
Carbon steel gears have hard, strong, and wear-resistant teeth. They’re best for heavy duty and high-torque applications, such as lifting equipment. However, these gears will rust when exposed to moisture or corrosive chemicals. Some gears have hardened teeth for additional wear resistance; gears with teeth that are not hardened can be hardened to fit your application.
For technical drawings and 3-D models, click on a part number.
Hub | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Gear Pitch | Number of Teeth | For Shaft Angle | Pressure Angle | Gear Pitch Dia. | OD | Face Wd. | Overall Wd. | For Shaft Dia. | Mounting Distance | Teeth Heat Treatment | Dia. | Wd. | Each | |
Round Bore—1144 Carbon Steel | ||||||||||||||
| 16 | 20 | 90° | 20° | 1 1/4" | 1.34" | 0.27" | 0.844" | 7/16" | 1.25" | Not Hardened | 1" | 0.5" | 0000000 | 000000 |