Search Results
    Clear All
    Roller Chain Trade Size
    Roller Chain Trade Size
    35
    40
    41
    50
    60
    80
    100
    System of Measurement
    System of Measurement
    Inch
    For Shaft Diameter
    For Shaft Diameter
    1 3/16"
    Material
    Material
    Steel
    Stainless Steel
    Iron
    Bore Type
    Bore Type
    Finished
    ID
    ID
    Show
    1 3/16"
    For Shaft Type
    For Shaft Type
    Round
    Keyed
    For Roller Chain Strand Type
    For Roller Chain Strand Type
    Single
    Keyway Width
    Keyway Width
    1/4"
    Shaft Mount Type
    Shaft Mount Type
    Set Screw
    Clamp On
    Keyway Depth
    Keyway Depth
    1/16"
    1/8"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Sprocket Type
    Sprocket Type
    Standard
    Roller Chain Standard
    Roller Chain Standard
    ANSI
    Teeth Heat Treatment
    Teeth Heat Treatment
    Hardened
    Taper
    Taper
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    210 Products

    Sprockets for ANSI Roller Chain

    For ANSI 35 Roller Chain (3/8" Pitch)
    For ANSI 40 Roller Chain (1/2" Pitch)
    Keyway
    Number
    of TeethFor Shaft
    Dia.ODOverall
    Wd.Hub Dia.Wd.Dp.MaterialIncludes Each
    For ANSI 41 Roller Chain (1/2" Pitch)
    For ANSI 50 Roller Chain (5/8" Pitch)
    Keyway
    Number
    of TeethFor Shaft
    Dia.ODOverall
    Wd.Hub Dia.Wd.Dp.MaterialIncludes Each
    For ANSI 60 Roller Chain (3/4" Pitch)
    Keyway
    Number
    of TeethFor Shaft
    Dia.ODOverall
    Wd.Hub Dia.Wd.Dp.MaterialIncludes Each
    For ANSI 80 Roller Chain (1" Pitch)
    For ANSI 100 Roller Chain (1 1/4" Pitch)

    Wear-Resistant Sprockets for ANSI Roller Chain

    For ANSI 35 Roller Chain (3/8" Pitch)
    For ANSI 40 Roller Chain (1/2" Pitch)
    For ANSI 50 Roller Chain (5/8" Pitch)
    For ANSI 60 Roller Chain (3/4" Pitch)
    For ANSI 80 Roller Chain (1" Pitch)

    Corrosion-Resistant Sprockets for ANSI Roller Chain

    Quick-Disconnect (QD) Bushings

    Taper-Lock Bushings

    Keyway
    For Shaft
    Dia.Overall
    Wd.Wd.Dp.TaperFastener Tightening
    Torque, in.-lbs.MaterialIncludes Each

    Split-Tapered Bushings

    Steel and Cast Iron

    Flush-Mount Screw-Clamp Bushings