Clear All
    System of Measurement
    System of Measurement
    Inch
    For Shaft Diameter
    For Shaft Diameter
    1 7/8"
    Roller Chain Trade Size
    Roller Chain Trade Size
    80
    Number of Teeth
    Number of Teeth
    13
    14
    15
    For Shaft Type
    For Shaft Type
    Keyed
    ID
    ID
    Show
    1 7/8"
    Material
    Material
    Steel
    Iron
    Pitch
    Pitch
    default
    1.000"
    Bore Type
    Bore Type
    Finished
    Shaft Mount Type
    Shaft Mount Type
    Set Screw
    Clamp On
    Keyway Depth
    Keyway Depth
    1/16"
    1/4"
    Keyway Width
    Keyway Width
    1/2"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Roller Chain Strand Type
    For Roller Chain Strand Type
    Single
    Hub Diameter
    Hub Diameter
    3"
    3 1/4"
    3 1/2"
    3 13/16"
    Roller Chain Standard
    Roller Chain Standard
    ANSI
    Sprocket Type
    Sprocket Type
    Standard
    Teeth Heat Treatment
    Teeth Heat Treatment
    Hardened
    Taper
    Taper
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    19 Products

    Sprockets for ANSI Roller Chain

    For ANSI 80 Roller Chain (1" Pitch)

    Wear-Resistant Sprockets for ANSI Roller Chain

    For ANSI 80 Roller Chain (1" Pitch)

    Quick-Disconnect (QD) Bushings

    Taper-Lock Bushings

    Split-Tapered Bushings

    Steel and Cast Iron