Push the lever to lock the handle and prevent accidental opening. The handle secures in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps. Move the holding screw to any position along the arm. To achieve maximum holding capacity, position the screw closest to the base. Capacity decreases by as much as 65% when the screw is positioned at the end of the arm.

For technical drawings and 3-D models, click on a part number.

Clamps with open arm allow you to move the holding screw to any position along the arm. Position the screw closest to the base to achieve maximum holding capacity. Capacity decreases by as much as 65% when the screw is positioned at the end of the arm.

Clamps with cut-to-length arm come in two pieces that must be welded together. Cut the arm to length, then weld the screw holder to the end of the arm. Holding capacity is for the arm length as supplied. Capacity increases when arm is cut and screw is positioned closer to the body of the clamp.

Stainless steel clamps have excellent corrosion resistance.

For technical drawings and 3-D models, click on a part number.

Push the lever to lock the handle and prevent accidental opening. Often used when assembling small parts, these small clamps have the holding strength of a full-size clamp. They have an open arm, so you can move the holding screw to any position along the arm. To achieve maximum holding capacity, position the screw closest to the base. Capacity decreases by as much as 30% when the screw is positioned at the end of the arm.

For technical drawings and 3-D models, click on a part number.

Often used to clamp lids and covers on containers, these bolt into place.

Stainless steel clamps have excellent corrosion resistance in wet environments.

For technical drawings and 3-D models, click on a part number.

Mount these clamps below a surface. They are often used to clamp lids and covers on containers.

For technical drawings and 3-D models, click on a part number.

Hold workpieces from the side.

Push/pull clamps secure in two positions—when the plunger is fully extended and when the plunger is fully retracted. They have an internally threaded plunger to accommodate threaded holding screws and other threaded fixtures (not included).

Stainless steel clamps have good corrosion resistance.

For technical drawings and 3-D models, click on a part number.

Also known as press screws, mount these clamps through a drilled hole and turn the crank to move the jaw end of the screw in and out.