Oversized to fit worn and enlarged holes, these pins work well as repair and replacement parts.

Cut this 12" stock to the length you need.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

A T-handle makes these pins easy to grip. Made entirely of stainless steel, they stand up to corrosive enviroments. Pins lock in place until you push the button to release the spring-loaded retaining balls.

The extra height and smaller width of the grip make the button more accessible in tight spaces. Made entirely of stainless steel, they stand up to corrosive enviroments. Pins lock in place until you push the button to release the spring-loaded retaining balls.

The extra height and smaller width of the grip make the button more accessible in tight spaces. For a more secure hold than standard quick-release pins, these pins lock in place until you push the button to release the spring-loaded retaining balls.

Four spring-loaded retaining balls provide extra holding power. Made entirely of stainless steel, these pins stand up to corrosive enviroments. They lock in place until you push the button to release the spring-loaded retaining balls.

To insert and remove these pins, press the button, then flip the lever to release the spring-loaded retaining balls. Two-step locking prevents accidental removal.

The smooth ring handle on these pins won't catch on parts. The shoulder keeps a portion of the pin outside the hole and makes them easy to grab.

Two spring-loaded balls give these pins more holding power than quick-release pins with only one retaining ball. The balls pop out when the pin is pushed into a hole, and retract when the pin is pulled out.

The smooth ring handle on these pins won't catch on parts. A spring-loaded, nonlocking retaining ball pops out when the pin is pushed through a hole, and retracts when the pin is pulled out.

Create a custom headed pin with your choice of material, dimensions, and end type.

To remove these pins, hit the small end with a punch to drive the pin out.

Weld these pins directly to a surface —no mounting hole required.

A flange keeps the plunger from being pushed through a hole when the ball is depressed.

Slotted on both ends for installation with a screwdriver.

Two holes in the plate allow these plungers to be mounted to a flat surface.

Install with a hex key for more torque than slotted ball-nose spring plungers.

An O-ring in the flange creates a tight seal.

The ring allows you to attach these spring plungers to a lanyard.

Quickly align, join, or hold machine components in place in food, pharmaceutical, and other sanitary environments. Pulling the plunger knob and twisting it 90° will lock the nose into its retracted position.

Use the lanyard as a tether to secure the spring plunger to machinery and prevent accidental drops.

A quarter turn of the handle locks these plungers in the retracted position. The smooth ball handle is easy to grip and won't catch on other parts.

An L-handle takes up less space than a T-handle.

A smooth ball handle is easy to grip and won't catch on other parts.