From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

When compared to standard 304 stainless steel, this material can be machined faster with less wear on cutting tools. It's also called Prodec and Project 70+.

Compare the appearance choices of our 304 stainless steel with these convenient selector packs.

Harder than our other 304 stainless steel, these thin sheets offer better wear resistance for use as a wrap, liner, or cover.

This wire bounces back after bending. It’s often used to construct springs and wire rope.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Able to withstand repeated stress and wear, 301 stainless steel has the strength required for applications such as springs and fasteners.

One side of these sheets has a brushed finish with grain lines running in one direction to mask fingerprints.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

This material is hardened for improved strength and wear resistance.

Widely used to fabricate fasteners and engine components, A286 will maintain its strength as temperatures rise.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

One side of these sheets is polished to either a brushed or mirror-like finish.

This wire will spring back after bending. It's often used to make springs and wire rope.

Because these thin sheets are harder than our other 316 stainless steel, they offer better wear resistance. Use them as a wrap, liner, or cover.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

Ready for turning in your lathe, these rods are precision ground to a tight tolerance.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

The width and thickness are oversized for finishing to your exact requirements.

One of the most machinable types of stainless steel available, 416 contains sulfur for fast machining without clogging cutting tools. It's used for gears, screws, and shafts.

Suitable for making molds, 420 stainless steel is a hard, wear-resistant material that can be finely polished to a very smooth surface.

The addition of vanadium and carbon gives 420V stainless steel excellent wear resistance. It can replace tool steel in highly abrasive applications.

Bend this wire and it will stay in place. It's commonly used as tying and locking wire.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

309/310 stainless steel has high levels of chromium and nickel to provide good corrosion resistance at elevated temperatures. It's often used in heat exchangers and furnaces.

Combine with a machine key to transmit torque to gears, sprockets, and other power transmission components.

Use these general purpose shafts with bearings, sprockets, and gears to transmit rotary motion.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.