Simple to use, these switches actuate with a quick push.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Save space on your panel by using one switch for several tasks. These switches actuate with the push of a button.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Immediately cut power with a single push.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Immediately cut power with a single push.

Save space on a panel by using one switch to perform multiple switching functions.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 10 mm dia. cutouts.

Install in 8 mm dia. cutouts.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

With a stainless steel enclosure, these switches are more durable than aluminum and plastic. They're rated NEMA 4X for protection from corrosion and washdowns.

Made of yellow polycarbonate plastic, these enclosed switches are easy to see and resist dents, chips, and cracks. They are more corrosion resistant than aluminum enclosed switches and withstand washdowns and oil/coolant spraying.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Often used to trigger alarms, these switches have a recessed button to prevent accidental activation. Mount under desks or in other discrete locations to avoid drawing attention.

Snap these switches onto your T-slotted framing rails—no need to drill or disassemble your existing structure.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Control machinery from a safe distance, or use these switches as call buttons.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Control machinery such as cranes, hoists, or trolleys with a wireless switch. About the size of a cell phone, these switches fit in the palm of your hand.

With a slim shape, these switches fit comfortably in your hand.

Also known as deadman switches, these switches make sure equipment only runs if you lightly press the hand grip. If you let go or a shock tightens your grip, they cut power.