We will reply to your message within an hour.
Made of aluminum, these spacers are lightweight and mildly corrosion resistant.
18-8 stainless steel spacers have good corrosion resistance.
These spacers have excellent corrosion resistance and are passivated for enhanced protection.
The zinc plating provides some corrosion resistance.
The anodized coating on these lightweight spacers provides increased abrasion resistance over uncoated aluminum.
Brass makes these spacers electrically conductive and the zinc-plated finish adds corrosion resistance.
Withstanding salt water, acids, and chemicals, these spacers resist corrosion better than any other metal spacer we offer. They have a high strength-to-weight ratio and are about 40% lighter than steel spacers.
These spacers have excellent wear and abrasion resistance. Exposure to moisture may cause them to expand.
Almost nonabsorbent, these unthreaded LDPE and HDPE spacers won't swell when exposed to water.
Polypropylene spacers have a hard surface and resist many chemicals and solvents.
Naturally slippery and wear resistant, acetal spacers also offer some resistance to moisture.
PTFE spacers have a slippery surface and surpass most plastic spacers when it comes to chemical resistance and performance in extreme temperatures.
Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.
Made of FDA-listed material, these clear spacers can be used in food and beverage applications.
Protect components from electrical charges.
Cut stock to the length you need.
An economical alternative to standard unthreaded spacers.
The 45° end fits against an angled surface to create a flat surface for connection.
Also known as shoulder washers.
These washers have a flat bottom and high walls to protect metal screw heads from electrical current.
As you tighten your screw, the rolled collar compresses under the head to create an insulating barrier between a screw shank and a mating surface.
Reinforce holes in soft material to keep them from collapsing around screws.
These aluminum inserts are lightweight, nonmagnetic, and mildly corrosion resistant.
A zinc-plated finish gives these steel inserts mild corrosion resistance.
Made from brass, these inserts are nonmagnetic, mildly corrosion resistant, and electrically conductive.
In addition to having a wider temperature range than our other vibration-damping bushings, these have excellent weather resistance.
Easier to install than grommets, push these bushings through your mounting hole to dampen vibration. Use them with a vibration-damping washer to isolate vibration.