Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Lock the nose into the retracted position by pulling the ring and rotating it 90°.

Lock the nose into the retracted position by pulling the handle and rotating it 90°.

Install by hand or with a hex key in low-clearance applications.

A quarter turn of the handle locks these plungers in the retracted position. The T-handle is easy to grip.

A quarter turn of the handle locks these plungers in the retracted position. The smooth ball handle is easy to grip and won't catch on other parts.

Add a knob or handle to the threaded shank.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Install with a hex key for more torque than slotted long-nose spring plungers.

These spring plungers have a nose that is about three-times longer than standard long hex-nose spring plungers.

Install with a hex key for more torque than slotted ball-nose spring plungers.

The flangeless design allows these spring plungers to mount flush with a surface.

Also known as tank-strap bolts, these T-bolts are commonly used with a band clamp or a strap to hold fuel tanks and other objects in place.

Install these pins in a plate or table and mate with holes in a workpiece for precise alignment.

Screw the shank into a threaded hole for quick installation and removal.

Encase these pins while molding plastic or composite parts. Once set, the knurls resist movement, letting you align the workpiece with precision on a plate or table.

When locating a workpiece using through-hole alignment pins, use one of these bushings and one standard bushing to prevent the pins from binding in your fixture.

Use the handle on these retractors to extend and retract a locating pin, protecting the pin from damage in applications where fixtures move through a process, such as along a conveyor belt.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.

Set the tang in a slot below the work surface to prevent thin material from sliding underneath the face.

Use these tools for easier guide pin installation.