Designed with a flange to keep the plunger from being pushed through a hole when the ball is depressed.

Install with a hex key for more torque than slotted ball-nose spring plungers.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Lock the nose into the retracted position by pulling the ring and rotating it 90°.

Lock the nose into the retracted position by pulling the handle and rotating it 90°.

Install by hand or with a hex key in low-clearance applications.

A quarter turn of the handle locks these plungers in the retracted position. The T-handle is easy to grip.

A quarter turn of the handle locks these plungers in the retracted position. The smooth ball handle is easy to grip and won't catch on other parts.

Add a knob or handle to the threaded shank.

Two holes in the plate allow these plungers to be mounted to a flat surface.

Use an arbor press or similar pressure tool to install these spring plungers into a panel.

Insert the nose into a panel; then thread on the nut and tighten using an installation wrench.

Install with a driver.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Fasten from the nose end with a wrench for more torque than slotted long-nose spring plungers.