Use these metal dowel pins as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Slip these pins in and out during maintenance or prototyping—they’re undersized to make alignment easier.

Grooves hold these pins in place, and a round head gives them a finished appearance.

Quarter-groove pins are well suited for hinges or pivots. The grooved end locks pins in position, while the smooth portion can act as a pivot. Also known as type C pins.

These pins make good hinges or pivots. The grooved half locks pins in position, while the smooth half can act as a pivot. Also known as type H pins.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

Center-knurled pins are often used in place of clevis pins or to create T-handles. The knurled center locks pins in position, while the smooth ends act as a pivot.

Use these pins to fasten components made of soft materials such as plastic or aluminum. Opposing barbs bite into each piece, pulling them together for a tight, secure fit.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Pass wires and other components through these hollow pins.

These internally threaded pins sit flush in an assembly. For easy removal from a blind hole, thread a screw into the pin and pull out.

Create a custom headed pin with your choice of material, dimensions, and end type.

Also known as round-head Type U drive screws.

Use in applications requiring high strength.

A zinc plating provides corrosion resistance in wet environments.