Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Two knurled sides provide micrometer-like movement for precise width adjustments.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Use a wrench to rotate your drive shaft without marring or gouging the shaft.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Mount these collars flush against each other or attach components to either side—the round body has flattened ends with tapped holes.

To install, slide these one-piece collars onto the end of your shaft.

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, slide these one-piece collars onto the end of your shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle.

These threaded handles take the place of a set screw, allowing you to move set screw shaft collars without additional tools—useful for when the collar serves as a stroke limiter or mounting clamp.

Often used in corrosive environments to support pipe passing through walls and floors, these collars are 303 stainless steel and sized specifically for a tight fit around pipe.

Sized specifically to adapt standard shaft collars to pipe, these bushings create a tight fit.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.