All of these bumpers are reinforced with an embedded washer or base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines. Install them with screws.

Select these bumpers for applications that require specific load capacities. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Install them with a screw.

Keep bumpers of various shapes, materials, and mounting styles on hand to solve whatever problems arise.

Install these stops in wood or concrete floors to protect walls from large doors in warehouses and manufacturing areas.

Designed to mount at the point of contact between a door handle and the wall, these stops prevent handles from damaging walls when doors swing open.

Simply screw these bumpers into baseboards with the attached self-tapping wood screw to prevent doors from damaging walls.

Protect large swinging doors where carts and vehicles are used to push the door open. These polyethylene plastic bumpers are commonly used on two-way swinging doors.

Protect walls and other surfaces from impact.

Vibrant colors create a visual alert to draw attention to equipment and obstructions. These guards protect walls and other flat surfaces from impact.

With a raised bulb to absorb greater impact than standard corner guards, these guards protect walls, cabinets, and other surfaces.

The guards in this system have a metal core for added strength and stability. Combine corner guards and surface guards to create a system that protects walls and equipment from impact and wear. Often used in warehouse and manufacturing areas, these systems protect against damage from carts and vehicles.

Create a tight seal around wire, cable, and cords with these grommets to keep out dust, debris, and moisture.

Cut the center of these grommets with a utility knife to create custom IDs. The two‐piece design makes it easy to install and seal these grommets around wire, cable, and cords that are already in place. Use them to keep out dust, debris, and moisture.

Mount through the counterbored hole with a socket head cap screw to support and position workpieces and fixtures from the bottom or side.

A two-piece design makes these mounts easier to install than one-piece mounts.

Made of neoprene rubber, these mounts are oil resistant, so they're good for use under generators, HVAC equipment, electric motors, pumps, and blowers.

An interlocking steel frame in these mounts prevents collapse, even if the rubber fails.

Isolate vibration and noise from oscillating equipment like fans and tumblers that create horizontal (shear) force.