Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

This welded, one-piece strut channel combines two strut channels back-to-back.

Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

Create continuous runs of channel without corners.

With welded ends, these short lengths of strut channel provide a finished look when mounting clamps and accessories to machines and surfaces.

Provide a stable, nonmarring base for strut channel legs.

Push these brackets into strut channel and tighten the included cam screws for a partially concealed connection.

A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

Connect two channels to create a stacked channel.

Push these nuts into place rather than threading them onto a fastener.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

Quickly attach these nuts by twisting them closed at any point along a threaded rod.

Keep hardware centered in the strut channel slot.

Notches on these washers grip the channel to keep them in place.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Provide smooth motion between two pieces of strut channel.

For quick mounting of components, these hangers snap into strut channels for a strong hold and easy repositioning.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.