This welded, one-piece strut channel combines two strut channels back-to-back.

Up to two times the height of regular strut channel, this high-profile channel is stronger than regular strut channel.

Slide the strut channel into the tube for telescoping length adjustments.

For compatibility with quick-connect clamps to secure pipe and conduit without screws and tools, this strut channel has narrow slotted holes.

Designed to wrap around the sides of strut channel, these brackets provide a stronger hold than other strut channel brackets.

These brackets have narrow slots compatible with quick-connect clamps for securing pipe and conduit on the channel side of struts without screws or tools.

Serrated grooves grip the lip of the channel.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

There's no need for additional fasteners with these nuts—they combine a strut channel nut with a spring and a threaded stud.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

A tab fits tightly against the lip of the channel to keep these nuts from slipping.

Use with hex nuts to connect threaded rod.

Notches on these washers grip the channel to keep them in place.

Securely fasten strut channel to the floor.

Mount a length of strut channel between the ends of a beam to run cable and conduit along the beam without drilling.

Brackets mount on the outside of strut channel to allow trolley movement.

Support the corners of strut channel structures.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Create a four-sided raceway for cable, or give a more finished look to strut channel structures.

Slip these hangers onto the lip of top-opening strut channel to attach chain, wire rope, pipe, and threaded rod.

Route pipe, tubing, and conduit across strut channel.

Even when these clamps are installed side by side, the clamping screws remain accessible. Use them to route pipe, tubing, and conduit across strut channel.

Secure insulated pipe to strut channel without pinching the insulation or exposing the pipe. These clamps are sized for use with insulated pipe and have a plastic insert that creates a seal around the insulation to prevent the pipe from sweating, which can cause mold and corrosion.

Slide these clamps into strut channel and snap closed for quick installation with no tools required. They are noncorrosive, nonconductive nylon.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.

These plastic hangers prevent corrosion caused by metal-to-metal contact. Push them closed for a more secure hold on material than loop hangers.

These general purpose gas springs assist in opening lids, covers, windows, conveyors, and seats—similar to a hatchback opening on a car.

Mechanical operation means these springs have no seals to fail or gas to leak.

A temperature-resistant seal allows these gas springs to withstand heat up to 392°F.

Sized with short stroke lengths and miniature dimensions, these gas springs are for opening small lids and doors, like those on toolboxes and access panels.

Color coded by force to help you choose the correct replacement, these gas springs generate high force in small spaces.

Protect material and equipment underneath heavy loads—these gas springs lock automatically when fully extended, ensuring they can't be closed until it's safe to do so.

Ensure you have the correct force for your application. These gas springs have a bleed valve so you can release gas to permanently reduce the force to meet your requirements.

Ensure you have the correct force for your application. These gas springs have a bleed valve so you can release gas to permanently reduce the force to meet your requirements.

Attach eyelet end fittings to these brackets to mount gas springs.

These brackets secure eyelet end fittings from both sides to provide a strong hold on gas springs that get bumped or jostled. Mount on any panel, lid, or door.