Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

This welded, one-piece strut channel combines two strut channels side-to-side.

Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

Create continuous runs of channel without corners.

Push these brackets into strut channel and tighten the included cam screws for a partially concealed connection.

Securely fasten strut channel to the floor.

A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

Also known as insert nuts, these convert slotted holes to threaded round holes and keep them centered in the channel.

Push these nuts into place rather than threading them onto a fastener.

Keep a rod securely centered against the strut channel.

Quickly attach these nuts by twisting them closed at any point along a threaded rod.

Add hardware to strut channel without having to hold the washer in place or reach inside the channel.

Keep hardware centered in the strut channel slot.

Brackets mount on the outside of strut channel to allow trolley movement.

Cover rough ends of strut channel.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Provide smooth motion between two pieces of strut channel.

Slip these hangers onto the lip of top-opening strut channel to attach chain, wire rope, pipe, and threaded rod.

Hold pipe, tubing, and conduit away from strut channel.

Secure insulated pipe to strut channel without pinching the insulation or exposing the pipe. These clamps are sized for use with insulated pipe and have a plastic insert that creates a seal around the insulation to prevent the pipe from sweating, which can cause mold and corrosion.

Slide multiple clamps into existing strut channel to organize lines of pipe, tubing, and conduit without the need for drilling, welding, or using adhesive. Clamps have a plastic or rubber cushion or body to reduce vibration.